How to maintain the workbench?

To maintain the technical performance of the workbench at all times, the initial setup, daily operation, and maintenance of the equipment are essential. If these matters are taken lightly, the performance of the equipment may deteriorate, and if maintenance is not carried out for a long time, it may cause damage to the equipment and make the workbench operate in an incomplete state. Therefore, we should learn the correct maintenance method. We will teach you some methods.

Here is the content list:

l How to maintain the anti-static workbench?

l How to maintain the ultra-clean workbench?

How to maintain the anti-static workbench?

Before using formaldehyde fumigation to sterilize the workbench, to prevent the leakage of formaldehyde, you should first use the "soap bubble" method to check the hermeticity of the whole machine.

Regularly (generally once every two months) with an anemometer to measure the work area wind speed, such as does not meet the requirements of the technical parameters, the fan power supply voltage can be adjusted.

When the fan voltage is adjusted to the maximum, the working area wind speed still cannot reach the requirements of the technical parameters, it is necessary to replace the air supply high-efficiency filter, replace the air supply high-efficiency filter must also be replaced at the same time the exhaust air high-efficiency filter. After the replacement, the dust particle counter should be used to check whether the seal around the edge is good, if there is leakage, it should be sealed with sealant.

The fan of the workbench does not need special maintenance, but it is recommended to conduct a regular inspection.

How to maintain the ultra-clean workbench?

It should be avoided as much as possible to make large and intense vibrations.

It is strictly forbidden to bring dust-producing items into the purification area.

According to the cleanliness of the environment, regular (generally 3 - 6 months) to the workbench of the filter media (non-woven) in the primary filter to remove the cleaning (when the filter media dust blackened, generally that should be cleaned or replaced).

Regularly (generally 1 time per week) sterilize the workbench environment, and often use gauze with alcohol or acetone and other organic solvents to wipe the UV lamp, so as not to affect the sterilization effect.

Regularly (generally 2 times a month) use a dust particle counter to measure the cleanliness of the clean area purified by this product. When the measured cleanliness does not match with the required cleanliness, the reason should be identified (whether there is leakage, whether the high-efficiency filter has failed, etc.). If the high-efficiency filter has failed, it should be replaced with a new high-efficiency filter.

When replacing the high-efficiency filter of the workbench, first remove the primary filter and air supply unit, then remove the pressure bar, then take out the failed high-efficiency filter, replace it with a new high-efficiency filter, and install the unloaded one back to its original position.

Ningbo Kinbox Tools Technology Co., Ltd. has been engaged in workbench research and development since 2013, and our products are known for their high quality.